Steps 15-22: Putting in vital methods
Step 15: Set up HVAC system
The HVAC technician will are available in to put in ductwork all through the home. The air handler, condenser, and trim work can be put in as effectively.
Step 16: Tough plumbing
A plumber will are available in and run pipes to the bogs, kitchen, and laundry room. They will even set up sewer traces, vents, and bathtubs.
This step might be performed whereas the doorways and home windows are being put in.
Step 17: Have an inspector consider the brand new plumbing
Though a licensed plumber might have performed the work, an inspector should are available in and examine the work to ensure every little thing is completed accurately.
The inspector will search for leaks and can be certain that the drains, sewage, and vent pipes move a strain check.
Step 18: Set up electrical wires and panels
This stage is when all the electrical work is completed.
The wires are run by way of the partitions and ceilings. The HVAC is connected (together with the thermostat), and the followers, lights, electrical retailers, exterior electrical work, and the circuit breaker are additionally connected and able to go.
Step. 19: Get an HVAC and electrical inspection
As soon as the HVAC and electrical work are full, an inspector will come out and ensure these methods work correctly and are accomplished to code.
Step 20: The roof is placed on the house
The sheathing for the roof is usually performed when the outside sheathing is hooked up to the partitions.
Throughout this stage, the roof can be accomplished. Roofers will set up the flashings and asphalt shingles — however different supplies could also be used, similar to clay or concrete tile, slate, steel, or wooden.
Step 21: Insulation is put in
The kind of insulation your property will want goes to rely in your location.
Normally, insulation is utilized to inside partitions, the attic, basement, crawl area, and exterior partitions (if it wasn’t utilized earlier than the sheathing).
The commonest forms of insulation are fiberglass, cellulose, or foam spray insulation.
Fiberglass insulation is utilized in unfinished partitions, flooring and ceilings. It is available in rolls and is put in in-between studs, joists, and beams. The common price for fiberglass insulation is between $0.30 to $1.50 per sq. foot.
Cellulose insulation is utilized in current and enclosed partitions or new open cavities within the wall. This insulation can be utilized in unfinished attic flooring and different hard-to-reach locations. This kind of insulation might be poured, however is normally blown into place utilizing particular gear. The common price of cellulose insulation is about $0.60–$2.30 per sq. foot.
Foam spray insulation is very similar to cellulose insulation, as it may be utilized in enclosed, current partitions, new wall cavities, and unfinished attic flooring. It’s utilized utilizing a sprig container (for smaller areas) or a strain spray product (for bigger areas). The common price of froth spray insulation is between $1 to $2 per sq. foot.
Step 22: Drywall is hung
Drywall is hung all through the inside of the home, in addition to on the ceiling.
Step 22b: The partitions and ceiling are textured
After the drywall is hung, a texture could also be sprayed on the drywall. Then, the partitions are primed to allow them to be painted.
